HD Fehler bei schnellen Test, jedoch nicht bei umfassenden Test

  • Hallo zusammen,


    beim schnellen Festplatten SMART Test erhalte ich folgende Warnung:



    Ich darauf hin dann den umfassenden Test durchgeführt, dabei wurde kein Fehler festgestellt. Nun meine Frage, wird beim umfassenden Test nicht das geprüft was beim Schnelltest geprüft wird bzw. auf welchem Test kann man sich verlassen?


    Ich verwende eine TS-419P-II Firmware 4.2.0


    Danke.

  • Hallo,


    vielleicht ein temporäres Problem? Vgl.: https://en.wikipedia.org/wiki/S.M.A.R.T.


    Zitat

    Current Pending Sector Count:
    Count of "unstable" sectors (waiting to be remapped, because of unrecoverable read errors). If an unstable sector is subsequently read successfully, the sector is remapped and this value is decreased. Read errors on a sector will not remap the sector immediately (since the correct value cannot be read and so the value to remap is not known, and also it might become readable later); instead, the drive firmware remembers that the sector needs to be remapped, and will remap it the next time it's written. However some drives will not immediately remap such sectors when written; instead the drive will first attempt to write to the problem sector and if the write operation is successful then the sector will be marked good (in this case, the "Reallocation Event Count" (0xC4) will not be increased). This is a serious shortcoming, for if such a drive contains marginal sectors that consistently fail only after some time has passed following a successful write operation, then the drive will never remap these problem sectors.


    Tritt das Problem beim erneuten Schnelltest denn wieder auf?

    Einmal editiert, zuletzt von dr_mike () aus folgendem Grund: Quote hinzugefügt.

  • Welches Build Datum der 4.2.0? höher als 4.2.0b1118? oder mindestens diese?