Alles anzeigenInstall with maximum operating frequency (optional)
The above command installs the standard Edge TPU runtime for Linux, which operates the device at a
reduced clock frequency. You can instead install a runtime version that operates at the maximum
clock frequency. This increases the inferencing speed but also increases power
consumption and causes the USB Accelerator to become very hot.If you're not certain your application requires increased performance, you should use the reduced
operating frequency. Otherwise, you can install the maximum frequency runtime as follows:sudo apt-get install libedgetpu1-max
You cannot have both versions of the runtime installed at the same time, but you can switch by
simply installing the alternate runtime as shown above.Caution: When operating the device using the maximum clock frequency, the metal on the USB Accelerator can become very hot to the touch. This might cause burn injuries. To avoid injury, either keep the device out of reach when operating it at maximum frequency, or use the reduced clock frequency.
Aktuell ist das teil hinter den Netzteil Lüfter damit es "etwas" von den Luftstrom abbekommt. Dank der div. USB Anschlüsse kann man ja einen USB Lüfter von Noctua anhängen wenn es notwendig wäre.
Das teil ist auch so modular aufgebaut das man (unter erllischen der Garantie) das teil einfach zerlegen könnte und einen CPU Kühler drauf packen könnten.
Nur die Frage ist wie kann man das im NAS einstellen "Hacken" das er die max. Speed Version nimmt? 
Lg