Das befürchte ich auch. Zuerst einmal Plätten, dann sehe ich weiter. Ich halte euch am Laufenden.
Habt ihr für das fortgeschrittene Problem noch andere Hinweise außer dieser Guide?
LG und danke für eure Antworten!
Hallo ihr!
Ich habe mich für einen kompletten Fw reset entschieden, nur leider komme ich nicht in den Recovery-Modus des TS-431+. Laut Anleitung sollte nach dem längeren Drücken der Copy-Teste das System in diesem Modus starten (erkennbar an der Rot leuchtenden LED), das passiert nicht, denn es blinkt nach einer längeren Zeit nur grün. Die Copy-Taste funktioniert aber. Es folgt kein tftp request laut Wireshark. Die restliche Konfiguration passt: tftp-server läuft und lässt sich auch per shell abrufen -> demnach kann das Netzwerk und der Server ausgeschlossen werden.
Habt ihr Ideen, bzw schon einmal ein TS-431+ DOM geflasht?
Herzlichen Dank schon einmal!
lg
- Download and install tftp server software to the Windows PC.
For 32-bit Windows: http://tftpd32.jounin.net/download/tftpd32.452.zip
For 64-bit Windows: http://tftpd32.jounin.net/download/tftpd64.452.zip - Download firmware files:
TS-831X: http://download.qnap.com/Stora…/fullimage/TS-831X_fw.zip
TS-531P: http://download.qnap.com/Stora…/fullimage/TS-531P_fw.zip
TS-231+/TS-431+: http://download.qnap.com/Stora…/fullimage/TS-X31+_fw.zip
TS-1635: http://eu1.qnap.com/Storage/tsd/fullimage/TS-1635_fw.zip - Launch tftp server application on the PC and configure the server settings like below.
Current Directory: Specify the directory where the firmware files are stored.
Server interfaces: Specify the network port on your PC which you configured IP address as 169.254.100.177. - Power off the NAS.
- Remove all of hard disks from the NAS.
- Connect the network cable to the specific network port of NAS.
(Attention: Please refer to below NAS photos to connect to correct port marked in blue.) - Press and hold USB copy button and then press power button to power on the NAS. Wait about 6 seconds until the status LED turns RED. Then release USB copy button.
(PS: TS-531P is the exception that the status LED will not turn red.) - The firmware recovery will automatically start and you can see firmware files downloaded from tftp server to NAS. (See below screenshot.)