Beiträge von twinkart

fdisk -1 bringt eine Fehlermeldung. Linux/Unix ist bei mir lange her (in den 80ern).
Hier die Daten:
[~] # dmesg
PCI INT B -> GSI 19 (level, low) -> IRQ 19
uhci_hcd 0000:00:1d.1: setting latency timer to 64
uhci_hcd 0000:00:1d.1: UHCI Host Controller
uhci_hcd 0000:00:1d.1: new USB bus registered, assigned bus number 7
uhci_hcd 0000:00:1d.1: irq 19, io base 0x0000a080
hub 7-0:1.0: USB hub found
hub 7-0:1.0: 2 ports detected
uhci_hcd 0000:00:1d.2: PCI INT C -> GSI 18 (level, low) -> IRQ 18
uhci_hcd 0000:00:1d.2: setting latency timer to 64
uhci_hcd 0000:00:1d.2: UHCI Host Controller
uhci_hcd 0000:00:1d.2: new USB bus registered, assigned bus number 8
uhci_hcd 0000:00:1d.2: irq 18, io base 0x0000a000
hub 8-0:1.0: USB hub found
hub 8-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usb: create proc systemp successfully
usb: create proc systemp successfully
usb 2-1: new high speed USB device using ehci_hcd and address 2
Using EHCI controller.
scsi10 : usb-storage 2-1:1.0
scsi 10:0:0:0: Direct-Access              USB DISK MODULE  PMAP PQ: 0 ANSI: 0 CCS
sd 10:0:0:0: Attached scsi generic sg23 type 0
sd 10:0:0:0: [sdx] 1007616 512-byte logical blocks: (515 MB/492 MiB)
sd 10:0:0:0: [sdx] Write Protect is off
sd 10:0:0:0: [sdx] Mode Sense: 23 00 00 00
sd 10:0:0:0: [sdx] Assuming drive cache: write through
sd 10:0:0:0: [sdx] Assuming drive cache: write through
 sdx: sdx1 sdx2 sdx3 sdx4 < sdx5 sdx6 >
sd 10:0:0:0: [sdx] Assuming drive cache: write through
sd 10:0:0:0: [sdx] Attached SCSI removable disk
kjournald starting.  Commit interval 5 seconds
EXT3-fs (sda1): mounted filesystem with writeback data mode
kjournald starting.  Commit interval 5 seconds
EXT3-fs (sdb1): mounted filesystem with writeback data mode
kjournald starting.  Commit interval 5 seconds
EXT3-fs (sdc1): mounted filesystem with writeback data mode
md: md9 stopped.
md: bind<sdb1>
md: bind<sdc1>
md: bind<sda1>
raid1: raid set md9 active with 3 out of 4 mirrors
md9: bitmap initialized from disk: read 5/5 pages, set 77095 bits
created bitmap (65 pages) for device md9
md9: detected capacity change from 0 to 542769152
 md9: unknown partition table
kjournald starting.  Commit interval 5 seconds
EXT3-fs (md9): using internal journal
EXT3-fs (md9): mounted filesystem with writeback data mode
md: md13 stopped.
md: bind<sdb4>
md: bind<sdc4>
md: bind<sda4>
raid1: raid set md13 active with 3 out of 4 mirrors
md13: bitmap initialized from disk: read 4/4 pages, set 81920 bits
created bitmap (57 pages) for device md13
md13: detected capacity change from 0 to 469893120
 md13: unknown partition table
kjournald starting.  Commit interval 5 seconds
EXT3-fs (md9): using internal journal
EXT3-fs (md9): mounted filesystem with writeback data mode
kjournald starting.  Commit interval 5 seconds
EXT3-fs (md9): using internal journal
EXT3-fs (md9): mounted filesystem with writeback data mode
kjournald starting.  Commit interval 5 seconds
EXT3-fs (md13): using internal journal
EXT3-fs (md13): mounted filesystem with writeback data mode
usbcore: registered new interface driver hiddev
usbcore: registered new interface driver usbhid
usbhid: USB HID core driver
Register ICH/PCH RTC driver.
iTCO_vendor_support: vendor-support=0
iTCO_wdt: Intel TCO WatchDog Timer Driver v1.05
iTCO_wdt: Found a ICH9R TCO device (Version=2, TCOBASE=0x0860)
iTCO_wdt: initialized. heartbeat=120 sec (nowayout=0)
usbcore: registered new interface driver usblp
ufsd: module license 'Commercial product' taints kernel.
Disabling lock debugging due to kernel taint
ufsd: driver U82 (Oct  2 2011 00:16:02) with acl LBD=OFF with ioctl loaded at f842e000
NTFS read/write support included
Hfs+/HfsX read/write support included
xhci_hcd 0000:05:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
xhci_hcd 0000:05:00.0: setting latency timer to 64
xhci_hcd 0000:05:00.0: xHCI Host Controller
xhci_hcd 0000:05:00.0: new USB bus registered, assigned bus number 9
xhci_hcd 0000:05:00.0: irq 17, io mem 0xfebfe000
usb usb9: config 1 interface 0 altsetting 0 endpoint 0x81 has no SuperSpeed companion descriptor
xHCI xhci_add_endpoint called for root hub
xHCI xhci_check_bandwidth called for root hub
hub 9-0:1.0: USB hub found
hub 9-0:1.0: 4 ports detected
fnotify: Load file notify kernel module.
fnotify:   Global_Private_Data_List_Init()
fnotify:   Launch the fnotify thread: 1622
fnotify:   The fnotify thread starts...
usbcore: registered new interface driver snd-usb-audio
usbcore: registered new interface driver snd-usb-caiaq
pci 0000:00:02.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
pci 0000:00:02.0: setting latency timer to 64
  alloc irq_desc for 38 on node -1
  alloc kstat_irqs on node -1
pci 0000:00:02.0: irq 38 for MSI/MSI-X
[drm] Initialized i915 1.6.0 20080730 for 0000:00:02.0 on minor 0
Linux video capture interface: v2.00
usbcore: registered new interface driver uvcvideo
USB Video Class driver (v0.1.0)
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
kjournald starting.  Commit interval 5 seconds
EXT3-fs (md9): using internal journal
EXT3-fs (md9): mounted filesystem with writeback data mode
active port 0 :139
active port 1 :445
active port 2 :20
e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX/TX
md: bind<sda2>
raid1: raid set md4 active with 1 out of 1 mirrors
md4: detected capacity change from 0 to 542769152
 md4: unknown partition table
Adding 530040k swap on /dev/md4.  Priority:-1 extents:1 across:530040k
md: md0 stopped.
md: md0 stopped.
md: bind<sdb2>
RAID1 conf printout:
 --- wd:1 rd:2
 disk 0, wo:0, o:1, dev:sda2
 disk 1, wo:1, o:1, dev:sdb2
md: recovery of RAID array md4
md: minimum _guaranteed_  speed: 5000 KB/sec/disk.
md: using maximum available idle IO bandwidth (but not more than 200000 KB/sec) for recovery.
md: using 128k window, over a total of 530048 blocks.
md: bind<sdb3>
md: bind<sdc3>
md: bind<sda3>
raid5: device sda3 operational as raid disk 0
raid5: device sdc3 operational as raid disk 2
raid5: device sdb3 operational as raid disk 1
raid5: allocated 50864kB for md0
0: w=1 pa=0 pr=3 m=1 a=2 r=3 op1=0 op2=0
2: w=2 pa=0 pr=3 m=1 a=2 r=3 op1=0 op2=0
1: w=3 pa=0 pr=3 m=1 a=2 r=3 op1=0 op2=0
raid5: raid level 5 set md0 active with 3 out of 3 devices, algorithm 2
RAID5 conf printout:
 --- rd:3 wd:3
 disk 0, o:1, dev:sda3
 disk 1, o:1, dev:sdb3
 disk 2, o:1, dev:sdc3
md0: detected capacity change from 0 to 1497099403264
 md0: unknown partition table
md: bind<sdc2>
EXT4-fs (md0): mounted filesystem with ordered data mode
md: md4: recovery done.
RAID1 conf printout:
 --- wd:2 rd:2
 disk 0, wo:0, o:1, dev:sda2
 disk 1, wo:0, o:1, dev:sdb2
active port 0 :139
active port 1 :445
active port 2 :20
warning: `proftpd' uses 32-bit capabilities (legacy support in use)
rule type=2, num=0
Loading iSCSI transport class v2.0-871.
iscsi: registered transport (tcp)
usb 2-2: new high speed USB device using ehci_hcd and address 3
Using EHCI controller.
scsi11 : usb-storage 2-2:1.0
scsi 11:0:0:0: Direct-Access     JetFlash Transcend 32GB   8.07 PQ: 0 ANSI: 2
sd 11:0:0:0: [sds] 62750720 512-byte logical blocks: (32.1 GB/29.9 GiB)
sd 11:0:0:0: [sds] Write Protect is off
sd 11:0:0:0: [sds] Mode Sense: 03 00 00 00
sd 11:0:0:0: [sds] Assuming drive cache: write through
sd 11:0:0:0: Attached scsi generic sg18 type 0
sd 11:0:0:0: [sds] Assuming drive cache: write through
 sds: sds1
sd 11:0:0:0: [sds] Assuming drive cache: write through
sd 11:0:0:0: [sds] Attached SCSI removable disk
active port 0 :139
active port 1 :445
active port 2 :20
usb 2-2: USB disconnect, address 3
Using EHCI controller.
active port 0 :139
active port 1 :445
active port 2 :20
[~] #




[~] # lsusb
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 002: ID 1005:b155 Apacer Technology, Inc.
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 006 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 007 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 008 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 009 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
[~] #




[~] # mount
/proc on /proc type proc (rw)
none on /dev/pts type devpts (rw,gid=5,mode=620)
sysfs on /sys type sysfs (rw)
tmpfs on /tmp type tmpfs (rw,size=32M)
none on /proc/bus/usb type usbfs (rw)
/dev/sda4 on /mnt/ext type ext3 (rw)
/dev/md9 on /mnt/HDA_ROOT type ext3 (rw)
/dev/md0 on /share/MD0_DATA type ext4 (rw,usrjquota=aquota.user,jqfmt=vfsv0,user_xattr,data=ordered,delalloc,noacl)
tmpfs on /.eaccelerator.tmp type tmpfs (rw,size=32M)
[~] #