Hallo,
habe heute meine neue TVS-882 bekommen und bin gerade mehr oder weniger erfolgreich dabei, die HDD's vom alten NAS in den neuen zu migrieren.
Habe dazu mal die Anleitung bemüht (QTS_4.3.x_SMB_en.pdf) und da TS-412 auf TVS-882 als "Supported for System Migration" drinnen steht, bin danach vorgegangen:
ZitatAlles anzeigenMigrating your NAS
Follow the steps below to perform system migration:
1. Turn off the source NAS and unplug the hard drives.
2. Remove the hard drives from the old trays and install them to the hard drive trays of the new NAS.
3. Plug the hard drives to the destination NAS (new model). Make sure the hard drives are installed in the original order.
4. Follow the instructions of the Quick Installation Guide (QIG) to connect the power supply and network cable(s) of the new NAS.
5. Turn on the new NAS. Login to the web administration interface as an administrator (the default login ID and password of the NAS are both "admin".)
6. If you are prompted to update the firmware of the new NAS, follow the instructions to download and install the firmware.
7. Click "Start Migrating". The NAS will restart after system migration. All the data and settings will be retained.
Punkt 1 - 6 sind kein Thema, Firmware habe ich aktualisiert, aber WTF mach ich mit Punkt 7?
Ich sehe nirgends einen Button wo "Start Migration" oben steht ...
Der Speichermanager sagt mir, dass ich keinen Pool angelegt habe, wie kann ich da jetzt die Migration durchführen/starten?